Re: Building CML after bootstrapping?

After you have compiled compiler, run config/install.sh again.

  - Vesa

On Sat, 23 Dec 2006, Geoffrey Alan Washburn wrote:

>
> 	I've just finished compiling and bootstrapping to a fixed point a
> modified version of SML/NJ, but I can't seem to figure what I should be
> doing to use this new compiler to rebuild CML.  I tried adding
> information about cml.cm into base/system/pathconfig, but it still
> complains that it doesn't know anything about the $cml anchor, which is
> used as part of cml.cm itself.
>
> 	Any suggestions would be appreciated.
>
>
> -------------------------------------------------------------------------
> Take Surveys. Earn Cash. Influence the Future of IT
> Join SourceForge.net's Techsay panel and you'll get the chance to share your
> opinions on IT & business topics through brief surveys - and earn cash
> http://www.techsay.com/default.php?page=join.php&p=sourceforge&CID=DEVDEV
> _______________________________________________
> Smlnj-list mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/smlnj-list
>

-- 
                                     /`---*\
                                    = ^ o ^ =
                                     `-----'

-------------------------------------------------------------------------
Take Surveys. Earn Cash. Influence the Future of IT
Join SourceForge.net's Techsay panel and you'll get the chance to share your
opinions on IT & business topics through brief surveys - and earn cash
http://www.techsay.com/default.php?page=join.php&p=sourceforge&CID=DEVDEV