Re: Visio XMI 1.0 import error

Visio has never supported any version of UML.  Their original
implementation, which apparently is basically unchanged in the Visio
2007 SR2 release, is kind of a bastardized pre-UML 1.3 type syntax.
It doesn't conform to any known standard.  It could probably be
pre-processed into something close enough to UML 1.3 that the ArgoUML
UML 1.3 -> UML 1.4 XSLT transform would be able to process it.

Tom

On Thu, Feb 11, 2010 at 1:45 PM, Bob Tarling <[email protected]> wrote:
> What version of UML does Visio 2007 support? ArgoUML currently only
> takes UML1.4 in the stable release.
>
> Regards
>
> Bob
>
> On 8 February 2010 20:32, Hannah <[email protected]> wrote:
>> I am having a similar error (same thing--when I try importing an xmi file generated in Visio 2007 to ArgoUML).  I tried deleting the the geometry tags and the doctype line, but I am still getting an error that says "Cannot set a multi-value to a non-multivalued attribute:multiplicity".  I attached the generated xmi file and the one I deleted the stuff out of.
>>
>> Many thanks!
>
> ------------------------------------------------------
> http://argouml.tigris.org/ds/viewMessage.do?dsForumId=449&dsMessageId=2446777
>
> To unsubscribe from this discussion, e-mail: [[email protected]].
>

------------------------------------------------------
http://argouml.tigris.org/ds/viewMessage.do?dsForumId=449&dsMessageId=2446894

To unsubscribe from this discussion, e-mail: [[email protected]].