Re: Boost compile libs continue

Thanks! So interrupting is, on my windows system, for example just 
pressing CTRL + C and then close?

------ Originalnachricht ------
Von: "Steven Watanabe via Boost-build" <[email protected]>
An: "Benjamin Müller via Boost-build" <[email protected]>
Cc: "Steven Watanabe" <[email protected]>
Gesendet: 23.05.2018 14:46:16
Betreff: Re: [Boost-build] Boost compile libs continue

>AMDG
>
>On 05/23/2018 06:14 AM, Benjamin Müller via Boost-build wrote:
>>
>>  I want to build the boost libs using gcc, but unfortunately I't not
>>  allowed to work on my PC more than one and a half hour, so I can't 
>>build
>>  it normally. This is my build command:
>>  b2 -j2 --build-dir=D:\boost_1_67_0\boost_1_67_0\Build toolset=gcc
>>  variant=debug link=static --build-type=complete stage
>>  I want to be able to stop it, and then continue building on another 
>>day,
>>  so that I can basically resume. Is that possible? Thanks!
>>
>
>   Of course.  Just interrupt it.  When you run the
>same command again it'll pick up where it left off.
>
>In Christ,
>Steven Watanabe
>_______________________________________________
>Unsubscribe & other changes: 
>https://lists.boost.org/mailman/listinfo.cgi/boost-build

_______________________________________________
Unsubscribe & other changes: https://lists.boost.org/mailman/listinfo.cgi/boost-build