Re: Path to compiler in configuration checks summary
Rene Rivera via Boost-build <[email protected]> Mon, 15 Apr 2019 12:06:24 -0500
| Newsgroups | gmane.comp.lib.boost.build |
|---|---|
| Message-ID | <CAHEh_GhtsmJd4ap1sQ_7L2E4pMnbudaS7VcOOdRYUbfjPCK2PA@mail.gmail.com> |
On Mon, Apr 15, 2019 at 11:52 AM Mateusz Loskot via Boost-build < [email protected]> wrote: > Hi, > > Is there any way to see path to compiler determined by b2 > but *before* compilation starts i.e. in summary of the configuration > checks, next to `default address-model`, etc.? > > I tried -d1 through -d4 and nothing is printed in the configuration checks > (-d5 and higher dump is enormous, less than useful for what I need). > > I can run -d2 and wait until compilation, then I can see the full compiler > command line and deduce the location from there, of course. > Wouldn't it be helpful to show it in the configuration summary? > AFAIK using "--debug-configuration" option prints out the compiler paths for all the toolsets that get configured. Did you try that option? -- -- Rene Rivera -- Grafik - Don't Assume Anything -- Robot Dreams - http://robot-dreams.net _______________________________________________ Unsubscribe & other changes: https://lists.boost.org/mailman/listinfo.cgi/boost-build