Re: Looking for some advices
Bryce Harrington <[email protected]>
| Newsgroups | gmane.comp.lib.cairo |
|---|---|
| Message-ID | <[email protected]> |
On Thu, Aug 28, 2014 at 09:30:43AM +0200, Alexandre Bique wrote: > Hi, > > I'm using cairo on Linux to render to screen. > > First I'd like to know the pros/cons of cairo's backends (xlib, xcb, gl). You didn't mention the image backend, but that should be discussed first. Its pros are that it is the most widely tested, has benefitted from a lot of optimizations, and seems to renders the best of all the backends. Since its a software renderer, performance is the principle con, but actually for many uses it has quite acceptable performance. In general you should prefer xcb over xlib. xcb is intended as the replacement for xlib. From my testing you should see little performance or functional difference between them. For distributable applications to be run on Linux desktops, I think gl can't be recommended. Most distributions don't ship with gl-enabled cairo, so you'd have to jump through hoops to get it. In theory, cairo-gl should be faster than cairo-xcb, at least for some operations. In practice the performance tends to be kind of a mixed bag. So if you're performance limited you might take a look to see if using it would help. Where gl (and egl) tends to be looked at the most is for embedded devices, but often in those cases you can do better by using a different drawing library more optimized for the egl case. Bryce -- cairo mailing list [email protected] http://lists.cairographics.org/mailman/listinfo/cairo