Re: Drawing raster
Lome More <[email protected]>
| Newsgroups | gmane.comp.lib.cairo |
|---|---|
| Message-ID | <[email protected]> |
Yes I have tried to draw on raster surface and then use it as dawing pattern for svg surface, but this way is not very sufficient solution and as you have to double your drawing operations plus it will be harder to place rasterized pattern on the exact same spot where the drawing operation should be. So I guess drawing operations depend only on surface types and can not be configued independently. -- Lome More -- cairo mailing list [email protected] https://lists.cairographics.org/mailman/listinfo/cairo