[PATCH] sparc: Fix static (non-PIE) executables when PIE is enabled by default

For the default --enable-default-pie, $(pic-default) adds -DPIC to
CPPFLAGS-.o so.  However, -fPIE ($(pie-default)) is only added to
CFLAGS-.o, which does not affect assembler (.S) sources

On SPARC the GOT register setup in SETUP_PIC_REG references
_GLOBAL_OFFSET_TABLE_ through %hi/%lo, and the assembler only rewrite
those into the required PC-relative relocations (R_SPARC_PC22 and
R_SPARC_PC10) when it is in *PIC* mode; otherwise it emits absolute
R_SPARC_HI22/R_SPARC_LO10.  With the absolute relocations the
__sparc_get_pc_thunk sequence adds the run-time PC to an already-absolute
GOT address, so the computed GOT register is wrong.  In _start this makes
the address of main come out bogus, and __libc_start_main jumps to an
unmapped address.

This removes the requirement of the --disable-default-pie for sparc
to build static binaries correctly.

Checked some tests (mainly the elf/ one) on a sparc64-linux-gnu
qemu system.
---
 sysdeps/sparc/Makefile | 11 +++++++++++
 1 file changed, 11 insertions(+)

diff --git a/sysdeps/sparc/Makefile b/sysdeps/sparc/Makefile
index 34c51cea6ba..6a58fcfd576 100644
--- a/sysdeps/sparc/Makefile
+++ b/sysdeps/sparc/Makefile
@@ -26,3 +26,14 @@ endif
 
 # The assembler on SPARC needs the -fPIC flag even when it's assembler code.
 ASFLAGS-.os += -fPIC
+
+# When PIE is enabled by default, the regular (.o) objects are also built as
+# PIC, as $(pic-default) adds -DPIC to CPPFLAGS-.o.  That makes the SPARC
+# assembler sources use the PIC GOT setup sequence, which refers to
+# # _GLOBAL_OFFSET_TABLE_ through %hi/%lo.  The assembler only turns those into
+# the required PC-relative relocations (R_SPARC_PC22/PC10) when it is in PIC
+# mode; without -fPIC it emits absolute R_SPARC_HI22/LO10 instead, so the
+# run-time GOT register is computed incorrectly.
+ifeq (yes,$(build-pie-default))
+ASFLAGS-.o += -fPIC
+endif
-- 
2.43.0