Installing GNUstep on Solaris and GNUstep gui on Windows NT

Hi,


We are a company called Orillion, we develop Telcecom Software especially Network Management Systems.

Here we are having a NMS called OVista which runs in OpenStep environment, and we are planning to port it to GNUstep. WE need all the help we can for this.

We could install GNUstep on our Solaris 2.6 machines, but were having few problems

    1.    Everything was installed , but the last utility GDNC could not be built, the following error came
 
 
*********************************************************************************
Undefined                       first referenced
 symbol                             in file
objc_thread_remove                  ../Source/shared_obj/sparc/solaris2.6/gnu-gn
u-gnu/libgnustep-base.so
objc_thread_add                     ../Source/shared_obj/sparc/solaris2.6/gnu-gn
u-gnu/libgnustep-base.so
ld: fatal: Symbol referencing errors. No output written to shared_obj/sparc/sola
ris2.6/gnu-gnu-gnu/gdnc
collect2: ld returned 1 exit status
make[3]: *** [shared_obj/sparc/solaris2.6/gnu-gnu-gnu/gdnc] Error 1
make[2]: *** [gdnc.build] Error 2
make[1]: *** [gdnc.all.tool.variables] Error 2
make[1]: Leaving directory `/u01/GnuStep/gnustep-base-1.0.2/Tools'
make: *** [internal-all] Error 2  
**********************************************************************************************  
 
    2.     After this when we build small applications they were getting built normally, but not so when we include Foundation Frameworks. Errors like above were coming 


    3. We are planning to port our client-side applications to GNUstep on NT. Foe that we understand first we need to install CYGWIN on NT. Our question is whether GUI of GNUstep runs on NT. The GNUstep document 'How-To" says only base is supported, gui backend not supported? Can we get any further help on it

my MailID [email protected] 

Thank you very much

N Ramana Rao
Systems Analyst,
ORILLION India Software Pvt Ltd.
Hyderabad,
India