Re: problem in using usrp n210 and wbx daughter board to receive signals

Hi Firas,

As far as I know GNU radio isn't related with GNUstep. So we can't 
help you in this way. Is better if write to the mailing list of GNU 
radio. Regards.

On 2013-05-10 23:20:48 -0600 Firas Serrge <[email protected]> 
wrote:

> hello ,
> i am new in usrp and GNU radio ,...
> i have usrp n210 and wbx (50-2200 Mhz) daughter board ,
> i have installed GRC on Ubuntu 12.04 LTS ,
> i wrote the .GRC file and generate the python code ...
> when i use my hardware to transmit a signals using ( usrp sink ) .... 
> there
> are interface and a signal will appears and no problems...
> 
> but when i 'm trying to receive signals (FM signals for example ) 
> ,... , in
> the usrp n210 motherboard .. the led C ( receiving) is on , but in the
> graphical interface .. no signal appear ...
> also i used the command ( " iptraf " ) to view if there are a traffic 
> on
> the interface eth0 ,
> there are traffic but the software dosen't comprehend the receiving 
> Data ,
> 
> //  UDP (52 bytes) from 192.168.10.20:49157 to 192.168.10.1:47842 on 
> eth0
> //  UDP (52 bytes) from 192.168.10.20:49157 to 192.168.10.1:47842 on 
> eth0
> 
> please help me .. i don't know why no signal appears in GUI ....
> 
> how may i receive signal ? and is there another method to receive 
> signal?
> 
> thanks you lot .
> _______________________________________________
> apps-gnustep mailing list
> [email protected]
> https://lists.gnu.org/mailman/listinfo/apps-gnustep
>