Re: [ITK-users] Recentering Output of fast marching

Hi,

This example shows how to find the bounding box of a binary image:

  https://itk.org/Insight/Doxygen/html/Examples_2SpatialObjects_2BoundingBoxFromImageMaskSpatialObject_8cxx-example.html

Hope this helps,
Matt

On Mon, Jun 26, 2017 at 12:39 PM, Andaharoo <[email protected]> wrote:
> I've been using the fast marching filter to segment out a particular piece of
> a 3d image and now I would like to recenter this segmented part. Sometimes
> the segmented part can be at the edge of the image which makes it hard to
> rotate since it will only rotate around the center. I tried using fast
> marchings getOutputOrigin but that doesn't do what I had hoped it would do.
> If I were to write it would go something along the lines of this with a
> binary image:
> for every pixel
>     if the pixel is 1
>         if the pixels x val is greater than maxX
>             maxX = the pixels x val
>         if the pixels x val is smaller than minX
>             minX = the pixels x val
>         Do the same with the y and z and mins
> Then after getting the extents I coudl just do (minX + maxX) / 2, (minY +
> maxY) / 2, (minZ + maxZ) / 2
>
>
>
> --
> View this message in context: http://itk-insight-users.2283740.n2.nabble.com/Recentering-Output-of-fast-marching-tp7590022.html
> Sent from the ITK Insight Users mailing list archive at Nabble.com.
> _____________________________________
> Powered by www.kitware.com
>
> Visit other Kitware open-source projects at
> http://www.kitware.com/opensource/opensource.html
>
> Kitware offers ITK Training Courses, for more information visit:
> http://www.kitware.com/products/protraining.php
>
> Please keep messages on-topic and check the ITK FAQ at:
> http://www.itk.org/Wiki/ITK_FAQ
>
> Follow this link to subscribe/unsubscribe:
> http://public.kitware.com/mailman/listinfo/insight-users
_____________________________________
Powered by www.kitware.com

Visit other Kitware open-source projects at
http://www.kitware.com/opensource/opensource.html

Kitware offers ITK Training Courses, for more information visit:
http://www.kitware.com/products/protraining.php

Please keep messages on-topic and check the ITK FAQ at:
http://www.itk.org/Wiki/ITK_FAQ

Follow this link to subscribe/unsubscribe:
http://public.kitware.com/mailman/listinfo/insight-users