Re: What TZ do you use to get right time w/ clockspeed?

Bennett Todd wrote:

>
> In other words, I'm guessing I'm a victim of what clockview(1)
> mentions "Beware that many systems do not handle leap seconds
> correctly in localtime."

Running clockspeed on all systems is the only cure, since the 22 seconds faster 
time is the correct time.  You can have a single source and run taiclockd to 
permit that to be synced by your other systems.  Also, see this page for helpful 
hints to set up clockspeed as a service managed by daemontools:

	http://fte.tegtmeyer.net/djbware/clockspeed_setup.html

HTH

John

-- 
John Peacock
Director of Information Research and Technology
Rowman & Littlefield Publishing Group
4720 Boston Way
Lanham, MD 20706
301-459-3366 x.5010
fax 301-429-5747