Re: [PATCH 0/1] Hard-float fenv support for PowerPc

Sebastian Huber <[email protected]>
Newsgroups gmane.comp.lib.newlib
Message-ID <[email protected]> 
On 05/06/2020 17:48, Eshan Dhawan wrote:

> Hi Sebastian,
>
> Did you run autoreconf -fvi in newlib directory.
> This patch only contains the hand written files
> No files generated by autoconf are included in this patch
> Are those files required to be included ??

Ok, could you please regenerate the files with the right 
Autoconf/Automake versions and send a patch. Please check that you can 
build GCC for powerpc-rtems with this patch and a clean repository 
without any untracked files.

Please do this also for the fenv patches for the other architectures.
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.