Re: Bike Balancing!

I just thought I'd give an update on how I'm going with the 
bike-balancing stuff

I'm not after total realism, just a way to control the leab angle of the 
bike to make it look real and stop it from falling over.

As a quick attempt at the "push force" I set it up so that a push/pull 
spring was setup at either side of the bike.  Think of two lines 
extending from the left and right sides of the bike that are parallel 
with a ground plane.

 From the ends of theses lines, I apply a force based on the distance 
from each point to a point above the COM of the bike.  The springs keep 
the bike up right, but it does tend to osccilate like crazy after some 
movement due to the complete lack of dampening forces (and probably 
because the spring force being applied is far too large)

But the general behaviour of balancing is there, it's just very crude 
and tends to break :op  But with a bit of tweaking it can be made to 
tilt/push the bike into a lean and back to the neutral position again 
depending on steering angle and speed.

I'm thinking that really, this could be done as a new constraint type 
that pushes and rotates a body sort of like the amotor joint does already.



Bram Stolk wrote:
>
>
>
>     Jon Watte wrote:
>
>     > If this is for research, ODE is not a good library to use, because
>     > bikes have gyroscopic forces that are not modeled in ODE.
>
>
> Jon, are you sure?
>
> Why do we have a --disable-gyroscopic flag in ODE's configure?
>
>   Bram
>  
> -- 
> Zapp: Captain's log, stardate...er..
> Kif: Ohhh. April 13th.
> Zapp: April 13th. Point 2. 


-- 

James Steele   

3D / Physics Programmer

 

[email protected]

 

Greentube Internet Entertainment Solutions AG

Mariahilfer Straße 47/1/102

A-1060 Wien

FN 197003k, HG Wien

 

Tel: +43 1 494 50 56

Fax: +43 1 494 50 56 - 14

http://www.greentube.com/

 

------------------------------------
Internet Email Confidentiality Footer
------------------------------------
Privileged/confidential information may be contained in this message. If 
you are not the addressee indicated in this message (or responsible for 
delivery of the message to this person), you may not copy or deliver 
this message to anyone. In such a case, you should destroy this message 
and kindly notify the sender by replying. Please make it known 
immediately  f you or your employer does not consent to the medium of 
e-mail for messages of this kind. Opinions, conclusions and other 
information in this message that do not relate to the official business 
of my firm shall be understood as neither given nor endorsed by it.