Fwd: Front and Rear sound is same

The front works once the device is changed into "DirectSound Default"
Everything works fine under DirectSound Default



---------- Forwarded message ----------
From: Kanishka Weerasekara <[email protected]>
Date: 16 March 2011 19:45
Subject: Re: [Openal] Front and Rear sound is same
To: [email protected]


Oh man, that was some mistake. I thought the y axis to be a plain parallel
to the ground.
Thank you very much. Problem solved. I bit of a problem. There seems to be a
blank sport right in front of me. The sounds come correct from rear left
rear right front left front right and accurately with the distance. Front
center and more distant in front center (1 and 2 points respectively) does
not play the sound.
You are a life saver. Thanks again.


On 16 March 2011 18:47, Chris Robinson <[email protected]> wrote:

> On Wednesday, March 16, 2011 6:55:49 PM Kanishka Weerasekara wrote:
> > I attached a sample i used to identify this problem. static float[]
> > sourcePos = {0.0f, 3.0f, 0.0f};
> > I hope 3.0f as the second array element should give sound from the rear
> > speakers. but it does not change if it's 3.0f or -3.0f ro 0.0f.
>
> The second value is Y, which is vertical movement (+up, -down). The third
> value is Z, which should do what you're expecting (+back, -front).
> _______________________________________________
> Openal mailing list
> [email protected]
> http://opensource.creative.com/mailman/listinfo/openal
>



-- 
|< /-\ |\| | S |-| |< /-\++
*http://ninetyninefree.blogspot.com/*





-- 
|< /-\ |\| | S |-| |< /-\++
*http://ninetyninefree.blogspot.com/*

_______________________________________________
Openal mailing list
[email protected]
http://opensource.creative.com/mailman/listinfo/openal