Re: binary locations in 1.5.0

Hi Swaroop,

I have not been involved with vocal code base for a very long time now,
last I remember binaries were created as you mentioned. However, you can
send your questions to [email protected] mailing list, I have CC'd that
to this email, and some one can respond with the current binary
locations.

Thanks.
--
Amit Bhadoria
Software Engineer
http://www.cisco.com 
-----Original Message-----
From: Swaroop Patel [mailto:[email protected]] 
Sent: Friday, February 11, 2005 6:41 AM
To: Bhadoria, Amit
Subject: 

Hey,
I saw your email address on vocal mailing list and I
would wondering if you would be willing to help me
with Vocal load generator.

I am very new to using both vocal 1.5.0 and Linux.  I
have successfully complied vocal on RedHat Linux 9.0
but I can not seem to figure out where the binaries
are located.  I am just trying to make a sip call with
elgee and have it loop back to elgee with a gateway in
between.  I know someone had installed vocal 1.4 on
this machine previously and 'lz' was located in
/vocal/loadgen/elgee/bin.release.../lz.  I was hoping
it would be same for vocal 1.5.0 but I don't see it.

I would appreciate if you can help me.
Thanks
Swaroop


		
__________________________________ 
Do you Yahoo!? 
Yahoo! Mail - Find what you need with new enhanced search.
http://info.mail.yahoo.com/mail_250

_______________________________________________
vocal mailing list
[email protected]
To unsubscribe, please go to http://www.vovida.org/mailman/listinfo/vocal