答复: [Vocal] FATAL ERROR during call setup

We are using intel 8x0 compatible sound card. To enable it full duplex we use ALSA driver instead of the i810_audio driver of Linux Redhat 9. The ALSA driver can be found at http://www.alsa-project.org/. Hope it helps.

Ma

> -----邮件原件-----
> 发件人: Arindam_Paul [mailto:[email protected]]
> 发送时间: 2005年2月18日 18:58
> 收件人: [email protected]
> 主题: [Vocal] FATAL ERROR during call setup
> 
> Hello,
> 
> We installed VOCAL and when running sipset, it's ringing properly. But at
> the reciever side, after accepting the call, we are getting "fatal error"
> popup message. From the error log, it is seen that it can be a problem with
> the sound card that we have. It says that, it requires full duplex sound
> card. Is there any way to make our sound card full duplex ???
> 
> Below are the kind of messages that we get,
> 
> 1. This card doesnot support full duplex.
> 2. We will try to proceed anyway
> 3. Variable to set audio output to mono ,may cause problems later .set to 2
> channels
> 4. Failed to set sample rate : Numerical result out of range.
> 
> 
> Thanks,

_______________________________________________
vocal mailing list
[email protected]
To unsubscribe, please go to http://www.vovida.org/mailman/listinfo/vocal