Re: How to run wxwidget application with DirectFB.

On Mon, 6 Nov 2023 04:39:58 -0800 (PST) Sivasubramanian Palanikumar wrote:

SP> I'm attempting to use the wxdfb library to execute a single frame.

 Just to be sure, is there a specific reason you're using wxDFB and not
some better supported port?

SP> I'm now using the 3.1.5 source of wxwidget,

 It's probably not going to change anything, as wxDFB has hardly been
changed since then, but there is really, really no reason whatsoever to be
using 3.1.5 right now. Please use 3.2.3 or the latest master.

SP> After the binary was built, I attempted to launch it by providing the 
SP> inputs listed below. However, I was unable to see the frame and instead 
SP> encountered other problems.

 Sorry, wxDFB is very outdated and unmaintained so I can't tell you why it
doesn't work for you. The last time I tried it it did show the window, but
it had plenty of problems. Maybe something broke it further since then...
In any case, if you really want to use wxDFB, you need to be ready to debug
and fix problems in it yourself.

 Otherwise, please use wxGTK under Linux which is actually supported.

 Regards,
VZ

-- 
TT-Solutions: wxWidgets consultancy and technical support
              https://www.tt-solutions.com/

-----BEGIN PGP SIGNATURE-----

iF0EABECAB0WIQQx+vLQdOwioQqkxtoG6kHeT2wehgUCZUkRvgAKCRAG6kHeT2we
hgmtAKCduqfctMXJ+NIQv2r5Nv6qHlhc0gCfTCy4zQeKb+Ewx/RtSInRVaBu60Y=
=n9qn
-----END PGP SIGNATURE-----