Questions and discussions about load-balance-paths

"Mr.R" <[email protected]> Mon, 29 Jan 2024 15:06:00 +0800
Newsgroups gmane.comp.linux.drbd
Message-ID <[email protected]> 
Hi all,

From the introduction of load-balance-Paths, I think it realizes the fault tolerance and load balancing of drbd network.

Below is my configuration file：
















/etc/drbd.d/drbd1.res：


resource drbd1 {
&nbsp;connection {
&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; path {
&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; host ha-155&nbsp; address&nbsp; 192.168.122.65:7789;
&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; host ha-156&nbsp; address&nbsp; 192.168.122.66:7789;
&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; }
&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; path {
&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; host ha-155&nbsp; address&nbsp; 192.168.122.155:7789;
&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; host ha-156&nbsp; address&nbsp; 192.168.122.156:7789;
&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; }
&nbsp;&nbsp; }
&nbsp;&nbsp; on ha-155 {
&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; device /dev/drbd1;
&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; disk&nbsp;&nbsp; /dev/sdb;
&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; meta-disk internal;
&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; node-id 1;
&nbsp;&nbsp; }
&nbsp;&nbsp; on ha-156 {
&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; device /dev/drbd1;
&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; disk&nbsp;&nbsp; /dev/sdb;
&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; meta-disk internal;
&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; node-id 2;
&nbsp;&nbsp; }
}



/etc/drbd.d/global_common.conf


net {
&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; load-balance-paths yes;
&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; }



After two network paths are created, run the drbdsetup events2 --now command to find that the two paths are connected.




After the second network is disconnected, run the drbdsetup events2 --now command to find that the two paths are still connected.




After the first network is disconnected, run the drbdsetup events2 --now command to find that both paths are disconnected.




According to my understanding, disconnect one of the networks and keep the other one connected, but the result is not so. 




What's my problem? Do you have any suggestions?




Thanks!