Re: Rendering issues with Finnish Umlauts in FinPR

NB. I did not change this key from the original

SourceType=GBF

Strictly speaking, even though IMP has been used for my rebuild ten years ago, if there were any significant GBF marker features in the source text, the mod2imp => imp2vs process would have preserved them.

Without looking again in detail, I cannot say for sure, but I'd guess there were none.

Best regards,

David

Sent with Proton Mail secure email.

------- Original Message -------
On Monday, January 23rd, 2023 at 10:03 AM, David Haslam <dfhdfh-g/[email protected]> wrote:


> Hi Dominique,
> 
> I just forwarded to you what I had sent to Cyrille.
> NB. It was sent from my btinternet address.
> 
> As for a TextSource key, the original text is barely altered.
> It's essentially still what was received from Tero Favorin (tero at favorin dot com) that was used to build Version 1.1 (see About key).
> All that's changed is the encoding fix and using braces {} instead of <> for recording the original chapter:verse references in some chapters.
> 
> cf. The first module release was squeezed into the default v11n (KJV).
> The fact that only Chris Little may have retained what was received from Tero is an unfortunate aspect of the past.
> 
> At some stage, we might consider scripting these references back to have an IMP file that matches the original av11n, and try rebuilding the module using (eg) Versification=German
> 
> Best regards,
> 
> David
> 
> Sent with Proton Mail secure email.
> 
> 
> ------- Original Message -------
> On Monday, January 23rd, 2023 at 9:27 AM, domcox [email protected] wrote:
> 
> 
> 
> > Hi David,
> > 
> > Please, send me the IMP file, I'll try to rebuild a module with
> > it.
> > I also need a TextSource value.
> > 
> > David Haslam dfhdfh-g/[email protected] writes:
> > 
> > > The problem is that CrossWire no longer accepts module
> > > submissions that use IMP format for the build process.
> > 
> > Best regards,
> > --
> > Dom
> > _______________________________________________
> > sword-devel mailing list: [email protected]
> > http://crosswire.org/mailman/listinfo/sword-devel
> > Instructions to unsubscribe/change your settings at above page
_______________________________________________
sword-devel mailing list: [email protected]
http://crosswire.org/mailman/listinfo/sword-devel
Instructions to unsubscribe/change your settings at above page