Re: diatheke - plain output error
David Haslam <dfhdfh-g/[email protected]>
| Newsgroups | gmane.comp.literature.sword.devel |
|---|---|
| Message-ID | <NHO86ewUOsJhfUirkUYHq9q-88AQoTd0Bs_U4tfIMIxjPeEt57BhvNEkbpTKj3f8t-Mt0CIQExwTmgB2rnZqFYhy27M8XUV6TpAziBl7-3k=@protonmail.com> |
Hi Peter, I just tried with diatheke.exe that is bundled with Xiphos for Windows. 4.2.1 (gtk2 webkit1) This may be based on an earlier version of SWORD. The utilities were all dated 2020-04-26. The plain filter did not show the fault you reported. eg. Genesis 1:15: And let them be for lights in the firmament of the heaven to give light upon the earth: and it was so. NB. On my current Windows 11 x64 system, I don't have the latest SWORD utilities. Greg was working on them a few weeks ago but his new procedure has not yet produced the desired results. Best regards, David Sent with Proton Mail secure email. On Tuesday, December 31st, 2024 at 4:53 PM, Peter von Kaehne <[email protected]> wrote: > Trying to use the diatheke and I note that it puts out incomplete > verses. (Diatheke > > peter@peter-thinkpadx220:~/Source/sword/utilities/diatheke$ ./diatheke > -b KJV -f plain -k Gen 15.1 > Genesis 15:1: After these things the word of the > (KJV) > > and > > peter@peter-thinkpadx220:~/Source/sword/utilities/diatheke$ diatheke -- > help > > Diatheke command-line SWORD frontend Version 4.8 (SWORD: 1.9.0.3893) > Copyright 1999-2018 by the CrossWire Bible Society > > I was going to check the bug tracker but as that is down I had no > chance, yet. > > The same error happens with the NASB. Reviewing the module - it appears > mainly that text inside tags vanishes, so I guess this is a filter > problem. > > I do not know who last laid hand at the plain filter set, but if others > confirm that this is an error and not a problem with my set up, I will > look further into this. > _______________________________________________ > sword-devel mailing list: [email protected] > http://crosswire.org/mailman/listinfo/sword-devel > Instructions to unsubscribe/change your settings at above page _______________________________________________ sword-devel mailing list: [email protected] http://crosswire.org/mailman/listinfo/sword-devel Instructions to unsubscribe/change your settings at above page