Re: Airport Extreme and DHCP
Carl Hoefs <[email protected]>
| Newsgroups | gmane.comp.macosx.general |
|---|---|
| Message-ID | <[email protected]> |
What I'm trying to do is the standard setup: [INTERNET] <===> [NETGEAR] <-WAN-> [AIRPORT] <-LAN-> (RJ45 devices) So, the Netgear has the Internet IP address, the Airport has 10.0.1.1, and the RJ45-connected devices have 10.0.1.x addresses. Not really using the WiFi at this point. It was working before it was reset. I first set the Airport up with the "genie" setup tool, and then when that didn't achieve an internet connection, I altered settings. Still no go. -Carl > On Sep 14, 2018, at 8:38 PM, Carl Hoefs <[email protected]> wrote: > > Our Apple Airport Extreme A1408 was working fine until some yokel decided to up and push the reset pin on the back. Now the Airport seems to have difficulty in obtaining an IP address via DHCP from our Netgear CM500 modem, regardless of the network settings I configure the Airport with. > > Here are the Airport settings: > > Connect using: DHCP > Subnet mask: 255.255.0.0 > DNS servers: 208.67.222.222, 208.67.220.220 > Domain name: opendns.org > Configure IPv6: Automatically > IPv6 mode: Native > Router mode: DHCP and NAT > DHCP range: 10.0.1.2 to 10.0.1.200 > DHCP lease: 1 day > IPv4 DHCP range: 10.0.1.2 to 10.0.1.200 > > Can anyone see what's gone wrong? > -Carl > > _______________________________________________ > MacOSX-talk mailing list > [email protected] > http://www.omnigroup.com/mailman/listinfo/macosx-talk