RE: Abaqus does not read table data

Does the *Boundary definition include a reference to the *Amplitude curve?

Regards,

Dave Lindeman
Staff Scientist
Corporate Research Systems Laboratory
3M Center 235-3G-08
St. Paul, MN 55144
651-733-6383

From: [email protected] [mailto:[email protected]]
Sent: Tuesday, July 17, 2018 10:14 AM
To: [email protected]
Subject: [EXTERNAL] [Abaqus] Abaqus does not read table data



Hello Everyone,



I face a wierd problem.



I have give abaqus a tabular data for displacement at a reference point. But the problem is, the load data is zero of some time and then it increases linearly.



But when I run the simulation, abaqus does not read the data from the amplitute tabular info, but starts with  a displacement which is linearly increasing.



Does anyone face this problem?



Thanks,

Aditya.







3M Note: This message is from an [EXTERNAL] sender.

If you suspect this message is malicious or spam, please click on the "Report Phishing - PhishMe" icon within the Outlook Ribbon to report it for evaluation, and do NOT open any attachments or click on any links. If you are using OWA, a handheld device, or do not see the icon, please follow the instructions below:
Click here<https://spam.mmm.com/pem/pages/digestProcess/digestProcess.jsf?content=aedaaa864ecbae94f5a5077beeaabab641f18251e7737a59b4a48e0d0ee776b7c6c4ff5fb22097b592aab29dac82584f30f60c161a797f8d8d8a621478a2f25250f75f3a4b570e12125b08ef0dd8e5d1dbc7a045714a146255659761471276b9c37b570f20a98a734732948327931bff7a1ab1d0bd24436f2c3880cbe962302417d051a1b719785d> to report this email as spam





[Non-text portions of this message have been removed]