Re: Turning off/on boundary condition in single step

"Mohammad Mozaffari [email protected] [Abaqus]" <[email protected]>
Newsgroups gmane.comp.mathematics.abaqus.user
Message-ID <[email protected]> 
Use Amplitude

On Jul 23, 2018 6:40 AM, "Moeen Saeed [email protected] [Abaqus]" <[email protected]> wrote:

Hi,

I am wondering if it’s possible to turn on/off a boundary condition in a single step?
For example I have a simply supported BC on one edge and I would like to turn it off after some time interval and turn on another BC by applying a simply supported BC on another edge?
Is this somehow possible?

Note: I know one can do that in two steps but I want to do it in a same step

Moeen
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.