Re: Re: Embed truss elements to solid elements for heat transfer analysis

"Suresh Babu [email protected] [Abaqus]" <[email protected]>
Newsgroups gmane.comp.mathematics.abaqus.user
Message-ID <CAATSxx2OasH0pPRoR3N9YdGxta=6UjABSY=_xbmrB7bvbUsgbQ@mail.gmail.com>
Dear all,
    Could you please help me in modeling Goldak's moving heat source using
DFLUX subroutine.
Thank you advance.

On Wed, Oct 3, 2018 at 5:28 PM Dimitrios Skordas [email protected]
[Abaqus] <[email protected]> wrote:

>
>
> Dear Mr. Papazafeiropoulos,
>
> Thank you very much for your response.
>
> My problem is that I want to simulate the fluid flowing inside the pipes,
> which creates heat flow from the inlet to the outlet of the pipe. This can
> be simulated in Abaqus only by specifying the mass flow rate and only
> forced convection elements can be used. This is why I don’t know if I can
> use temperature-displacement elements for my problem.
>
> However it would be very helpful if you shared with me your .inp file and
> try to find a solution using these elements.
>
> Best regards,
>
> Dimitris
>
> Στάλθηκε από το iPhone μου
>
> 2 Οκτ 2018, 09:14, ο χρήστης «[email protected] [Abaqus] <
> [email protected] <[email protected]>>» έγραψε:
>
>
>
> Dear Mr. Skordas,
>
> There are no diffusive heat transfer truss elements in Abaqus, and
> therefore, the embedded element technique cannot be used for heat transfer
> analysis. Besides this, I assume that the concrete piles need to include
> displacement and rotational degrees of freedom in the analysis. Heat
> transfer analysis cannot be used for models containing displacement and
> rotational degrees of freedom.
>
> However, there are coupled temperature-displacement solid elements (C3D8T)
> and coupled temperature-displacement truss elements (T3D2T), and
> therefore, you can perform a coupled temperature-displacement analysis
> (*COUPLED TEMPERATURE-DISPLACEMENT) using these truss elements embedded in
> the solid elements.
>
> I can share with you an example input file with which a simulation
> containing T3D2T elements embedded in C3D8T elements is performed.
>
> Best regards,
> _______________________________________________
> George Papazafeiropoulos
> Captain, Infrastructure Engineer, Hellenic Air Force
> Civil Engineer, M.Sc., Ph.D. candidate, NTUA
> Email: [email protected]
>
> 
>


-- 
 with regards,
      G.Suresh,
      Research Scholar,
      Ph 7658988444.
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.