Impact drop Simulation in Abaqus

"Lucifer [email protected] [Abaqus]" <[email protected]> Wed, 31 Oct 2018 21:53:40 -0700 (MST)

Newsgroups	gmane.comp.mathematics.abaqus.user
Message-ID	<[email protected]>

I was doing a impact simulation with high velocity of a container assembly by
dropping it on a rigid surface. During simulation i have considered ductile
damage rule. at the end of simulation, some part of container assembly pass
through the rigid surface after element deletion. i have applied general
contact feature during simulation all with itself.


Regards,
Lucifer



--
Sent from: http://abaqus-users.1086179.n5.nabble.com/