Re: Nonlinear spring modification in Abaqus 2017 input file

"'Guo, Yongjin (Y)' [email protected] [Abaqus]" <[email protected]>
Newsgroups gmane.comp.mathematics.abaqus.user
Message-ID <BN6P164MB0003CBD9B47C92B28AF7A2F2FECA0@BN6P164MB0003.NAMP164.PROD.OUTLOOK.COM> 
That means the nonlinear feature has not been implemented and supported in CAE. However, it IS supported by the Abaqus solver. Thus you can directly modify the INPUT file and run your simulation directly from the INPUT file (using the command line mode). NOT from within CAE. Hope this answered your question.

Best regards,
Yongjin

------------------------------------------------------
Yongjin Guo
Materials Engineering Center
Corporate R&D, Dow Chemical
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.