Re: Nonlinear spring modification in Abaqus 2017 input file
| Newsgroups | gmane.comp.mathematics.abaqus.user |
|---|---|
| Message-ID | <[email protected]> |
Dear Phil, Yes, so I tried to define nonlinear spring in the input file as described in Abaqus user's guide. However, after defining nonlinear spring in the input file, ABAQUS did not seem to read "nonlinear" keyword when the input file was imported. Do you have any idea for this issue? Thank you, Hoonill ---In [email protected], <phil@...> wrote : Dear Hoonill Note that nonlinear spring behaviour is not available in CAE. It can only be defined in the input file (or as a keyword edit in CAE). Alternatively you could define a nonlinear spring using a connector instead, which can be done using CAE. More information is given in the Abaqus Analysis User's Guide. Kind regards Phil Williams Simutech.com.tw