Re: Contact surface and User element

Hi Sundar,

Thanks a lot for your reply and advise.

I am using surface to surface contact.

I will try with more elements.

Kind Regards

*Surya*


On Thu, 15 Nov 2018 at 11:41, sundar raman [email protected]
[Abaqus] <[email protected]> wrote:

>
>
> hi
> did you check with the type of contact .surface to surface or node to
> surface.  check with adjust and also try by giving more elements to master
> and slave.
>
> with reg
> Sundar
>
> On 14 Nov 2018 17:29, "Surya Ghimire [email protected] [Abaqus]" <
> [email protected]> wrote:
>
>
>
>
> *Hi All,*
>
> *I am trying to study the failure **behavior** of a beam with three point
> bending using user defined element. I am applying load by using a loading
> cell with displacement control. I defined a contact surface in between top
> surface of the beam and bottom **surface** of the loading cell but
> loading cell is penetrating. *
>
> *I would be pleased to get some ideas to resolve this issue.*
>
> *Thanks and regards*
>
> *Surya*
>
>
> 
>