Re: Contact surface and User element
| Newsgroups | gmane.comp.mathematics.abaqus.user |
|---|---|
| Message-ID | <CAFKQkJhvT=P=St-xoAqyAFV0e7g=nC77jYgDPgQ+iBeK1obMBQ@mail.gmail.com> |
What kind of element do you define in user subroutine? Element for contact? Then define zero penetration in uel. On Nov 16, 2018 4:09 PM, "Surya Ghimire [email protected] [Abaqus]" < [email protected]> wrote: > > > Hi Sundar, > > Thanks a lot for your reply and advise. > > I am using surface to surface contact. > > I will try with more elements. > > Kind Regards > > *Surya* > > > On Thu, 15 Nov 2018 at 11:41, sundar raman [email protected] > [Abaqus] <[email protected]> wrote: > >> >> >> hi >> did you check with the type of contact .surface to surface or node to >> surface. check with adjust and also try by giving more elements to master >> and slave. >> >> with reg >> Sundar >> >> On 14 Nov 2018 17:29, "Surya Ghimire [email protected] >> <[email protected]> [Abaqus]" <[email protected]> wrote: >> >> >> >> >> *Hi All,* >> >> *I am trying to study the failure **behavior** of a beam with three >> point bending using user defined element. I am applying load by using a >> loading cell with displacement control. I defined a contact surface in >> between top surface of the beam and bottom **surface** of the loading >> cell but loading cell is penetrating. * >> >> *I would be pleased to get some ideas to resolve this issue.* >> >> *Thanks and regards* >> >> *Surya* >> >> >> >