Re: Error in my model

"[email protected] [Abaqus]" <[email protected]> 04 Dec 2018 01:46:06 +0000

Newsgroups	gmane.comp.mathematics.abaqus.user
Message-ID	<[email protected]>

Hi In Abaqus/CAE you need to define the material, create a section and assign it to the geometry. This error message implies that part of your model is missing a section assignment.
 If you're using skins or stringers to define the reinforcement, you may need to select these separately by choosing Skin/Stringer from the Selection toolbar.
 

 Kind regards
 Phil Williams
 Simutech.com.tw