Re: Re: Error in my model
| Newsgroups | gmane.comp.mathematics.abaqus.user |
|---|---|
| Message-ID | <CA+0vb7ivjB39SOmJC+6MNP4qqSyBiXAjzBRif+8hMEoVYvfp3g@mail.gmail.com> |
I have assigned it to the geometry a lot of times, but still its not working. The reinforcement doesn't takes the assigned section it seems. When I try to make them dependent then the mesh goes away. *Gayatri Thakre* Graduate Research Assistant | Zachry Department of Civil Engineering Civil Department Delegate | Graduate and Professional Students Council Texas A&M University Mob: 979.739.7402 <%28979%29%20739-7402> Email :[email protected] :gayatrithakre11@ <[email protected]>gmail.com - - - - - - - - - - - - - - - - - - - - - - - - *TEXAS A&M UNIVERSITY* | FEARLESS on Every Front. ᐧ On Mon, Dec 3, 2018 at 11:10 PM [email protected] [Abaqus] < [email protected]> wrote: > > > Hi > In Abaqus/CAE you need to define the material, create a section and assign > it to the geometry. This error message implies that part of your model is > missing a section assignment. > If you're using skins or stringers to define the reinforcement, you may > need to select these separately by choosing Skin/Stringer from the > Selection toolbar. > > Kind regards > Phil Williams > Simutech.com.tw > > >