Re: need help to part model
| Newsgroups | gmane.comp.mathematics.abaqus.user |
|---|---|
| Message-ID | <[email protected]> |
Hello, As far as I know there is not such capability in Abaqus/CAE. However, you can insert directly the coordinates of the points of the geodesic curve in the Abaqus input file and then perform the analysis normally. Therefore, if you can calculate the coordinates of the points of the geodesic curve in an external software then you can paste them inside the input file and run the Abaqus analysis. Best regards, _______________________________________________ George Papazafeiropoulos Captain, Infrastructure Engineer, Hellenic Air Force Civil Engineer, M.Sc., Ph.D. candidate, NTUA Email: [email protected]