Re: Re: Non-convergence due to "time increment is less than minimum specified"
"patrick Grossman [email protected] [Abaqus]" <[email protected]> Tue, 15 Jan 2019 13:38:15 +0000 (UTC)
| Newsgroups | gmane.comp.mathematics.abaqus.user |
|---|---|
| Message-ID | <[email protected]> |
do you have any messages in the .msg file that may indicate rigid body motion? have you looked in the visualizer diagnostics to see which nodes are not converging?
On Tuesday, January 15, 2019, 6:57:13 AM EST, [email protected] [Abaqus] <[email protected]> wrote:
Dear Guru,
The first thought that comes in mind is that there may be some kind of failure of the plate in the case that you have used nonlinear material. Is the analysis static?
Best regards,_______________________________________________
George Papazafeiropoulos
Captain, Infrastructure Engineer, Hellenic Air Force
Civil Engineer, M.Sc., Ph.D. candidate, NTUA
Email: [email protected]