Setting Boundary Conditions to Nodes

"[email protected] [Abaqus]" <[email protected]> 28 Jan 2019 20:13:46 +0000

Newsgroups	gmane.comp.mathematics.abaqus.user
Message-ID	<[email protected]>

Hi all,
 

 Is there a quicker way of setting boundary conditions to nodes other than creating a set? FOr my project i have to have several steps releasing a boundary condition on each node 1 by 1. The problem i have is if i change the mesh i have to do this process all over again.
 

 kind regards,
 Bilal