Re: DFLUX MULTI PASS WELDİNG SUBROUTINE

"[email protected] [Abaqus]" <[email protected]> 04 Apr 2019 18:57:24 -0700

Newsgroups	gmane.comp.mathematics.abaqus.user
Message-ID	<[email protected]>

but, there is a error when i run it. I think it does not comes from IF statement problem. How can i describe the surface names in subroutine? 

  weld3.for(24): error #6321: An unterminated block exists.       IF(SNAME.EQ.'BEAD_1')THEN
 ^
 weld3.for(17): error #6321: An unterminated block exists.
       IF(SNAME.EQ.'BEAD_2')THEN