RE: ARM with Qemu

Hi Adam,

>Other issue could be a missing CONFIG_AEABI.

Thanks for your reply and your time. Nonetheless the CONFIG_AEABI is enabled in L4linux:

#
# Kernel Features
#
[...]
CONFIG_AEABI=y
CONFIG_OABI_COMPAT=y
[...] 

>But I suppose you tried that already?

I have already tried the configuration file this way with the same result (I can reach the end of the boot but I have no input and I can enter into the jdb in Qemu).

Thanks in advance for your help,

Nicolas

-----Message d'origine-----
De : l4-hackers [mailto:[email protected]] De la part de Adam Lackorzynski
Envoyé : mardi 17 mars 2015 23:11
À : [email protected]
Objet : Re: ARM with Qemu

Hi Nicolas,

On Mon Mar 16, 2015 at 10:41:21 +0100, Nicolas VARONA wrote:
> >FPU support also needs to be enabled in Fiasco. I suppose it is?
> 
> I had already enabled FPU in Fiasco like this:

Ok, good.

> I checked the CPACR register and the bits look ok. VFP is also enabled on the board. So you are right, it seems to be something else.

Other issue could be a missing CONFIG_AEABI.

> >Which ramdisk are you using?
> 
> I use the ramdisk given in the files in the l4re-snapshot-2014092821: "ramdisk-arm.rd"

ok.

> >Do you have the 'log = L4.Env.log' statement in the script for launching L4Linux?
> >Do not start anything else which uses 'log = L4.Env.log'.
> 
> I firstly tested adding this log without commenting the others. I don't have inputs on L4linux with Qemu. So I tried with only the 'log = L4.Env.log'. I have the same result with no input and I still can enter into the JDB.
> This is the "l4lx.cfg" file I used:
> -- vim:set ft=lua:
> 
> local lxname = "vmlinuz";
> if L4.Info.arch() == "arm" then
>   lxname = "vmlinuz.arm";
> end

You need to have it like this:

 L4.default_loader:start(
   { caps = {
       log = L4.Env.log:m("rws"),
     },
   },
   "rom/" .. lxname .. " mem=64M console=ttyLv0 l4x_rd=rom/ramdisk-" ..  L4.Info.arch() .. ".rd root=1:0 ramdisk_size=4000");

But I suppose you tried that already?

> >What is Linux telling us about ttyLv0?
> 
> During the boot with the configuration file I gave you, I can see:
> [...]
> ttyLv0 at MMIO 0x1 (irq = 211, base_baud = 230400) is a L4
> [...]

That looks fine.



Adam
-- 
Adam                 [email protected]
  Lackorzynski         http://os.inf.tu-dresden.de/~adam/

_______________________________________________
l4-hackers mailing list
[email protected]
http://os.inf.tu-dresden.de/mailman/listinfo/l4-hackers