Re: Problem with Hello app on Zedboard
Adam Lackorzynski <[email protected]>
| Newsgroups | gmane.comp.micro-kernel.l4.devel |
|---|---|
| Message-ID | <[email protected]> |
Hi, On Fri Dec 11, 2015 at 15:02:16 +0200, Manolis Ragkousis wrote: > Hello everyone, > > I am trying to make the Hello app run on the zedboard but it gets stuck > at "Scanning up to 512 MB RAM, starting at offset 32MB". > > I have configured both fiasco and l4re with the correct configuration (I > have attached my config files) and cross compiled them from a x86_64 > linux machine with "Linaro GCC 4.9-2014.09 4.9.2 20140904". > > I searched the mailing lists archives but I can't seem to find a similar > problem. I tried changing the uart port I was using, in case it was > printing in another port, but nothing changed. > > Any ideas/suggestions on what could go be going wrong and/or how can I > solve it? > > Loading Device T^H.��.\\Build: #2 Fri Dec 11 14:35:25 EET 2015, 4.9.2 > 20140904 (prerelease) > Scanning up to 512 MB RAM, starting at offset 32MB This looks like some UART issue. I suppose Linux is running ok? What does it say on its UART/tty init? And does this happen everytime in the same way or does the pattern change? Adam -- Adam [email protected] Lackorzynski http://os.inf.tu-dresden.de/~adam/ _______________________________________________ l4-hackers mailing list [email protected] http://os.inf.tu-dresden.de/mailman/listinfo/l4-hackers