Re: [mh] 2413S vs 2413U
Spencer Ryan <[email protected]>
| Newsgroups | gmane.comp.misc.misterhouse.user |
|---|---|
| Message-ID | <CALWY-YpBuXxYVKqKObL=goYm4TEWP-+_WFSepwwzeXayO+SizA@mail.gmail.com> |
100% sure. I've never used the set button on any of my ~30 devices (all I2CS) for linking except for a factory reset. The "Security" is you have to know the destination ID to initiate a remote linking. On Sun, Dec 6, 2020 at 12:49 PM Marc MERLIN <[email protected]> wrote: > On Sun, Dec 06, 2020 at 11:14:22AM -0500, Spencer Ryan wrote: > > The procedure for this is basically you basically just go through every > > device in MisterHouse and pick the "Link to Interface" option. Then once > > that is done you force an all link scan, then you remove orphan links > > (Which will remove the old PLM from the devices databases) and then a > sync > > So, for my new devices, I thought I had to push the button once to link > them, as a security measure (someone can't just plug inside an outside > outlet on your house, start linking to devices and then sending them > commands). > > Are you sure you can link to a new I2CS device without ever touching its > button? > > Marc > -- > "A mouse is a device used to point at the xterm you want to type in" - > A.S.R. > > Home page: http://marc.merlins.org/ | PGP > 7F55D5F27AAF9D08 > ________________________________________________________ To unsubscribe from this list, go to: https://lists.sourceforge.net/lists/listinfo/misterhouse-users