Re: [mh] loss of connection to plm
DoumP <[email protected]> Thu, 1 Dec 2022 12:08:21 -0500
| Newsgroups | gmane.comp.misc.misterhouse.user |
|---|---|
| Message-ID | <[email protected]> |
Both the plm and a 3d printer use a usb to serial, so they must be fighting for the serial port. I don't know how to fix it but there must be a way to force which serial port to use? Le 2022-11-28 à 16 h 27, hoodcanaljim a écrit : > Hi > On ubuntu 20.04 mh is running is running fine but now that I am > using Cura to slice for my printer I lose the connection to the plm > ever time i run it. I then have to use systemctl to stop/start mh again. > Is there anything I can do to fix it so it doesn't disconnect? > > Thanks > Jim > > > ________________________________________________________ > To unsubscribe from this list, go to: > https://lists.sourceforge.net/lists/listinfo/misterhouse-users > ________________________________________________________ To unsubscribe from this list, go to: https://lists.sourceforge.net/lists/listinfo/misterhouse-users