Re: protege-discussion Digest, Vol 75, Issue 11
Timothy Redmond <[email protected]>
| Newsgroups | gmane.comp.misc.ontology.protege.general |
|---|---|
| Message-ID | <[email protected]> |
On 10/9/12 6:13 PM, Ganesh kumar wrote: > Hi, > Thanks for your very quick response. > The information you provided is very helpful. > > is there a way to do it without copying the .pprj file but to solely > depend on the database alone ? Yes - follow these steps: > Failing that, you can connect directly to the database project from > Protege using the new project menu (perhaps not too intuitive). Do > the following: > > 1. In the "Welcome to Protege" (or in the File menu) select new project. > 2. **Very important** - make sure that the "Create from existing > sources" is checked. > 3. Choose either OWL/RDF database or Protege database depending on > whether your project is an OWL database project. > 4. (Assuming you chose OWL/RDF) choose OWL Database in the next window. > 5. Then you get a window where you can enter your configuration > parameters. > The one thing that you want to avoid is overwriting the database with a new empty copy. That is why it is important that the "Create from existing sources" is important. -Timothy > > Thanks so much for you help. > > _______________________________________________ protege-discussion mailing list [email protected] https://mailman.stanford.edu/mailman/listinfo/protege-discussion Instructions for unsubscribing: http://protege.stanford.edu/doc/faq.html#01a.03