Re: Fwd: How to figure out how to add support for another phone
"Stephen Wood" <[email protected]>
| Newsgroups | gmane.comp.mobile.bitpim.devel |
|---|---|
| Message-ID | <[email protected]> |
Many of the Sanyo phones have similar protocols. What features were you able to get to work? Try also reading the phonebook with the SCP-3100 setting. If you can get BitPim to run from source, I may be able to talk you through adding support. But no garuantees. Stephen On 6/1/06, David Melgar <[email protected]> wrote: > > > > ---------- Forwarded message ---------- > From: David Melgar <[email protected]> > Date: Jun 1, 2006 1:53 AM > Subject: How to figure out how to add support for another phone > To: [email protected] > > I'm sure its been asked before but I didn't see a clear answer. > > Any hints and tips to figure out how to successfully talk to a new phone > model? In particular I'd like to see how hard it is to figure out the > protocol for the Sanyo MM-7500. I read /trunk/bitpim/dev-doc/phonespec.html, > it talked a good bit about how to develop in BitPim but didnt discuss too > much how to reverse engineer how to talk to a phone. Some features work to > the 7500 by calling it a MM-8300, but phonebook syncing in particular > doesn't work. > > Thanks > > _______________________________________________ BitPim-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/bitpim-devel