Re: wap push handset
Stipe Tolj <[email protected]>
| Newsgroups | gmane.comp.mobile.kannel.devel |
|---|---|
| Organization | Wapme Systems AG |
| Message-ID | <[email protected]> |
Zhou Ye wrote: > Also is any special hardward needed in the telco to handle WAP Push, or can we use say SMPP or UCP straight to a conventional SMSC and be OK? How should the message be composed? I did not answer all, so here is the rest. No, there is no special hardware required. WAP Push messages are encapsulated as "normal" SMS messages (if you use SMS as bearer) in the UDH data segment. WAP Push architecture is described in detail at the according specification from the WAP Forum, see http://www.wapforum.org/what/technical.htm BTW, Kannel has PPG (push proxy gateway) and PI (push initiator) support build in. All glory and blame go to Aarno in this case :)) Stipe [email protected] ------------------------------------------------------------------- Wapme Systems AG Münsterstr. 248 40470 Düsseldorf Tel: +49-211-74845-0 Fax: +49-211-74845-299 E-Mail: [email protected] Internet: http://www.wapme-systems.de ------------------------------------------------------------------- wapme.net - wherever you are