Simple problem?

Hi there,

apologies if this is something basic that i could find in help files or
something, but i did scour them, and the archive for this list.

Just a simple question. I am running the stable version of Kannel (1.0.3)
on Red Hat 7.1.

I have Kannel up and running fine (tested with fakesmsc), and want to use a
Siemens M20 for I/O to Kannel. I have tested my M20 with minicom, and it is
responding fine (only at 9600 speed though)... However, when i try and run
the bearerbox with the m20 as smsc i get the following error  :
************************
************************
[root@score kannel]#bearerbox -v 1 /etc/kannel/test.conf
2002-02-19 11:05:31 [0] INFO: Debug_lvl = 1, log_file = <none> log_lvl = 0
2002-02-19 11:05:31 [0] INFO: Reading configuration from
</etc/kannel/test.conf>
2002-02-19 11:05:31 [0] INFO: ------------------------------
2002-02-19 11:05:31 [0] INFO: Kannel bearerbox II version 1.0.3 starting
Coimmand ATE0
2002-02-19 11:05:31 [0] PANIC: Cannot start with SMSC connection failing
***********************
***********************
When using mimicon i would get an OK response to the ATE0 command from the
M20.

suggestions about what i should do?

current smsc group in the test.conf looks like this:

group = smsc
smsc = at
modemtype = siemens
device = /dev/ttyS0

(i also tried it with alt-dcs = 0 or 1, and with speed=9600... but not sure
if you can do that with this version of at)


Thanks for your help,

Thomas Larkin