Re: [PATCH] SMS message center support for AT2 module.

I've applied your patch (with some minor changes (*)) and will commit
tomorrow morning
(my cable modem doesn't allow cvs or else there's some bad routing)


(*) I'm using Octstr instead of that temp[500], added the configuration
reading
and, acording to the standard (and my ericsson said the same), it misses the
quotas
It's AT+CSCA="number"

Could please others try it using an international number, to see if it's
necessary to
add the ",145" to the end when we have a "+"?


----- Original Message -----
From: "Oded Arbel" <[email protected]>
To: "Kannel-devel (E-mail)" <[email protected]>
Sent: Wednesday, February 13, 2002 11:33 AM
Subject: [PATCH] SMS message center support for AT2 module.


Hi list.

Sorry for the onslaught of patches ;-) I just want to get this out of
the door. I needed to change the SMS message center setting of the SIM
card, and really didn't feel like going into minicom and start to play
with AT commands.
so in a typical bout of "programmer-think", I hacked Kannel to do this
for me...

The change is minimal, tested and "Works For Me(tm)" on our wavecom test
platform, but as usual - YMMV.

Patch attached (this time, I swear :-)

Oded Arbel
m-Wise Inc.
[email protected]

--
"My ambition is handicapped by laziness."
-- Bukowskis Alter Ego Henry Chinaski in "Factotum"
 <<smsc_at2.patch>>