Re: [RFI+Patch] AT2 Modems.conf

Bruno David Rodrigues wrote:
> 
> Attached to this message is a patch to at2 to have modem definitions
> outside the source
> 
> I want you to test it and check if it's working and some
> comments/advise to some issues:
> 
> 1. I'm opening a "kannel.conf" that is hard coded on the code. It's
> not easy to pass the full

shouldn't be hard coded IMO.

> 6. in modems definition, I've included a keepalive-cmd. This way, I
> can set ericsson and Nokia to do a
> AT+CBC;+CSQ and receive +CBC: 0,63 (on batery, 63% full) and +CSQ:
> 15,99 (gsm signal quality) :)

Hmm, so this is only displaying "additional" information to the log.
What about using the batery and signal quality to route/load balance
sms between different GSM modem. I think of scenarios where a usually
routed SMS goes to smsc-id A and if that has been detected to be out
of network it should route to smsc-id B, or similar.

I try to add this to the proposed features section in STATUS.

> 7. At line 520, I've set timeout waiting for +CPIN reply to 10
> seconds, could you test it with the that
> modem that takes too long to reply?
> 
> 8. added a colon to +CMT search (+CMTI:) to prevent it from
> receiving +CMTI:
> 
> 9. Where's the sim/me memory patch ? ;)

It should be noted in STATUS, or at least it's in the devel@ archive.

Stipe

[email protected]
-------------------------------------------------------------------
Wapme Systems AG

Münsterstr. 248
40470 Düsseldorf

Tel: +49-211-74845-0
Fax: +49-211-74845-299

E-Mail: [email protected]
Internet: http://www.wapme-systems.de
-------------------------------------------------------------------
wapme.net - wherever you are