RE: speed (smsc_at2.c)

I think that at2 should autodetect speed if it doesn't find any speed
setting, in the smsc group or modems.conf, or if the smsc speed setting
is set to 0 regardless of the modems.conf setting, or the modems.conf
setting is set to 0 - isn't that the case now ?

--
Oded Arbel
m-Wise Inc.
[email protected]

Real questions asked by lawyers in real courts :
20)Q: Do you recall approximately the time that you examined the body of
Mr. Edington at the rose Chapel? 
A:It was in the evening. The autopsy started about 8:30 p.m. 
Q:And Mr. Edington was dead at the time, is that correct? 
A:No, you stupid, he was sitting on the table wondering why I was doing
an autopsy!


> -----Original Message-----
> From: Bruno David Rodrigues [mailto:[email protected]]
> Sent: Tuesday, March 26, 2002 6:40 PM
> To: Andrea Viscovich; [email protected]
> Subject: Re: speed (smsc_at2.c)
> 
> 
> 
> ----- Original Message -----
> From: "Andrea Viscovich" <[email protected]>
> To: <[email protected]>
> Sent: Tuesday, March 26, 2002 4:27 PM
> Subject: Re: speed (smsc_at2.c)
> 
> 
> > >If you set the modemtype, kannel will use the group from 
> modems.conf, and
> > if speed
> > >is unset in it, kannel uses 9600.
> > >If you explicitly want kannel to autodetect, use speed = 0 
> in smsc group.
> >
> > I would have preferred to not set speed=0 to have it autodetect.
> 
> We can ask for opinions on the list...
> 
> If we choose the modem, should kannel autodetect the speed or try to
> autodetect?
> 
> Andrea wants to kannel always autodetect speed unless it's 
> explicity set in
> smsc group
> 
> I chosed to have a known working speed in modems.conf and use 
> it, and only
> force
> autodetect if we want.
> 
> I'm ok with both solutions. What do the others think about it ?
> 
> 
>