Re: Rif: RE: speed (smsc_at2.c)
Stipe Tolj <[email protected]>
| Newsgroups | gmane.comp.mobile.kannel.devel |
|---|---|
| Organization | Wapme Systems AG |
| Message-ID | <[email protected]> |
[email protected] wrote: > > > I think that at2 should autodetect speed if it doesn't find any speed > > setting, in the smsc group or modems.conf, or if the smsc speed setting > > is set to 0 regardless of the modems.conf setting, or the modems.conf > > setting is set to 0 - isn't that the case now ? > > No. Now you must set speed=0 if you want speed to be autodetected, otherwise it behaves as you > set speed = 9600. > That's why I think if no speed is specified than it should be autodetect. +1 from me. If no 'speed' directive is specified in the group, autodetect should be used, because you don't have a garantee that a 9600 speeded device is attached to the port. Stipe [email protected] ------------------------------------------------------------------- Wapme Systems AG Münsterstr. 248 40470 Düsseldorf Tel: +49-211-74845-0 Fax: +49-211-74845-299 E-Mail: [email protected] Internet: http://www.wapme-systems.de ------------------------------------------------------------------- wapme.net - wherever you are