Re: sendsms and smsc parameter

Well, I'm sorry Stipe.
I just thought that setting smsc was enought, instead I realized that I
should
set preferred-smsc-id to themselves for each smsc group, and now it works.
Just one question.
Now I have
..
smsc-id = A
preferred-smsc-id = A
..
..
smsc-id = B
preferred-smsc-id = B
...
etc. for each modem.
If I send 10 sms setting smsc=A they will be all delivered by A or after the
first one kannel detects
A is busy and forward it to B?
Thanks
Andrea


----- Original Message -----
From: "Stipe Tolj" <[email protected]>
To: "Andrea Viscovich" <[email protected]>
Cc: <[email protected]>
Sent: Friday, April 26, 2002 6:35 PM
Subject: Re: sendsms and smsc parameter


> Yes the docs tell the truth.
>
> In general specifying a "&smsc=foobar" in the GET request should route
> the message to the specific smsc-id = "foobar".
>
> Can you provide us a kannel.conf setup and example GET request where
> this is failing?
>
> Stipe
>
> [email protected]
> -------------------------------------------------------------------
> Wapme Systems AG
>
> Münsterstr. 248
> 40470 Düsseldorf
>
> Tel: +49-211-74845-0
> Fax: +49-211-74845-299
>
> E-Mail: [email protected]
> Internet: http://www.wapme-systems.de
> -------------------------------------------------------------------
> wapme.net - wherever you are
>