Re: CMTI support in AT2

Yes should do that too quite happily. I'm using to coax a limited capacity 
device into working however it will work quite normally with any CMTI 
message received.

Cheers. Alex

On Tue, 30 Apr 2002, Andrea Viscovich wrote:

> >
> > Patch attached to add CMTI support to the AT2 driver. You'll need to add a
> > new definition to your configuration file specifying that the init string
> > for the phones you want to use this is AT+CNMI=1,1,0,0,0 rather than
> > 1,2,0,0,0 and then define your smsc.
> 
> I don't understand. I think it can be used even with  AT+CNMI=1,2,0,0,0
> In this case only few sms will go throught sim, that's why we
> need to check the +CMTI
> Otherwise with AT+CNMI=1,1,0,0,0 every sms will go throught sim.
> By the way thanks :-)
> Andrea
> 

-- 
Alex Judd
http://www.skywire.co.uk