Re: smpp unbind

Wayne Smithers wrote:
> 
> What happened to this code from 1.0.3 in 1.1.6
> 
> smsc_smpp.c:    /* Push a UNBIND PDU on the [smsc->fifo_r_out] stack. */
> smsc_smpp.c:    pdu->id = SMPP_UNBIND;
> smsc_smpp.c:    /* Push a UNBIND PDU on the [smsc->fifo_t_out] stack. */
> smsc_smpp.c:    pdu->id = SMPP_UNBIND;
> smsc_smpp.c:    /* Write out the UNBIND PDUs. */
> smsc_smpp.c:    /* If states are BOUND then push UNBIND messages to
> smsc_smpp.c:    case SMPP_UNBIND_RESP:
> smsc_smpp.c:    case SMPP_UNBIND_RESP:
> smsc_smpp.c:    case SMPP_UNBIND_RESP:
> smsc_smpp.c:    case SMPP_UNBIND:
> smsc_smpp.c:    case SMPP_UNBIND_RESP:
> smsc_smpp.c:*  UNBIND, UNBIND_RESP
> smsc_smpp.h:#define SMPP_UNBIND                   0x00000006
> smsc_smpp.h:#define SMPP_UNBIND_RESP              0x80000006
> 
> Was this replaced with something else ?
> 
> I need to send an unbind notification to a SMSC which was done by default in
> 1.0.3 when certain signals were received by the bearerbox process.
> In the dev version 1.1.5 & 1.1.6 the connection is just terminated, no
> unbind is sent.

please use our ViewCVS interface to figure out who changes the unbind
behaviour any hopefully also why.

Stipe

[email protected]
-------------------------------------------------------------------
Wapme Systems AG

Vogelsanger Weg 80
40470 Düsseldorf

Tel: +49-211-74845-0
Fax: +49-211-74845-299

E-Mail: [email protected]
Internet: http://www.wapme-systems.de
-------------------------------------------------------------------
wapme.net - wherever you are